Concrete RemovalVirginia Beach, VA
Saw-cutting, breaking and hauling of slabs, driveways, pool decks, footings and pads.
Concrete removal covers everything from a cracked driveway to a commercial parking pad or foundation slab. The job is mostly about control: cutting clean edges where concrete meets work that stays, keeping dust and slurry under management and getting heavy debris out without damaging the base or neighboring pavement.
In Virginia Beach, concrete work meets the local ground. Sandy, often wet soil can make the subgrade soft once a slab is lifted, and a high water table can fill the excavation. We plan the removal and the base repair together instead of treating them as separate jobs.
Scope & Specifications
- Typical scopes
- Driveways, patios, pool decks, garage and commercial slabs, footings, curbs and equipment pads
- Cutting
- Wet saw-cutting to the removal line; slurry captured and managed
- Breaking
- Hydraulic breaker or processor, depending on thickness and reinforcement
- Reinforcement
- Rebar and wire mesh cut free, collected and sorted for metal recycling
- Subgrade
- Base inspected after removal; soft areas flagged before new concrete is placed
- Debris
- Hauled to concrete recycling or disposal as facility acceptance allows
Equipment We Use
Walk-behind and hand-held wet saws
Cut clean joints so removal stops exactly where intended
Skid steers and mini excavators with breakers
Break and lift slabs in tight residential and commercial yards
Concrete processors
Crush thick or heavily reinforced sections and separate rebar
Vacuum and slurry collection equipment
Control wet-cutting residue near storm drains and landscaping
Plate compactors and stone
Re-establish the base where replacement concrete or paving follows
Dump trucks and roll-off containers
Haul broken concrete and reinforcing steel
How the Work Is Sequenced
Locate and mark
Utility locates are requested through Virginia811, irrigation and drainage lines are identified, and removal limits are marked on the surface.
Cut the perimeter
Saw-cut lines separate the removal area from concrete that stays, preventing ragged edges and cracking beyond the work zone.
Break and lift
Breakers or processors reduce the slab to loadable pieces while water holds dust down; reinforcing steel is cut free.
Check the base
With the slab out, the subgrade is checked for softness and water; stone or fill is added and compacted if replacement is planned.
Haul and protect
Debris leaves the site, slurry and fines are kept off storm drains, and the work area is cleaned.
Safety & Compliance
Rules, thresholds and fees change. Use these as a checklist of what to confirm, and rely on the issuing agency for current requirements.
OSHA silica standard (29 CFR 1926.1153)
Cutting and breaking concrete creates respirable crystalline silica; the standard calls for engineering controls such as water or vacuum, and respiratory protection where needed.
Virginia811
Locates are requested before excavation or breaking that can reach buried lines.
OSHA 29 CFR 1926 Subpart T (Demolition)
Applies to the removal of structural concrete such as slabs, foundations and footings.
Stormwater and erosion controls
Slurry and sediment must not reach storm drains or waters; larger disturbed areas can require Virginia erosion and stormwater review. Confirm with the City of Virginia Beach Development Services Center.
Right-of-way permits
Curb, sidewalk and street-edge work needs City authorization through Public Works; confirm what applies before cutting.
Virginia Beach Considerations
Local note 1
Pool decks and patios on waterside lots can sit close to a Resource Protection Area buffer, so how debris is staged and how the area is stabilized afterward can matter.
Local note 2
Where a slab sits on sandy fill, removal can leave a loose base; we flag it before replacement concrete is poured rather than after.
Local note 3
Many commercial slabs in Hilltop and along the Laskin Road corridor are tied to drainage structures and utilities in parking fields, so locates and drainage protection come before the first cut.
Concrete Removal FAQs
Yes. We saw-cut a clean line so the section that stays is not damaged, and we can match the cut to a layout for new concrete.
It creates slurry, which we collect and keep out of storm drains. The method is used because it controls silica dust.
It is cut free and sorted for metal recycling where practical.
Work in the public right-of-way generally needs City approval. Confirm with Public Works before removing anything between the property line and the street.
Related Virginia Beach Demolition Guides
- structural demolition in Virginia BeachControlled mechanical teardown of houses and commercial buildings, from utility disconnects to a stabilized lot.Read more →
- debris hauling and site clearing in Virginia BeachRemoving demolition waste and clearing lots so the site is ready for survey, grading or construction.Read more →
- commercial strip-out in Virginia BeachSelective removal of finishes and building systems in hotels, condos, shops and offices, with the structure left standing.Read more →
- Concrete removal and hauling in Virginia BeachThe main service page for this trade, with pricing factors and a quote form.Read more →
- demolition cost, permits and inspections in Virginia BeachWhat drives demolition cost, and the permit and inspection steps to plan for.Read more →
- Virginia Beach demolition contractorsResidential, commercial, interior and concrete demolition across the metro.Read more →
Serving Oceanfront Resort Area demolition, Town Center demolition, Hilltop demolition, Great Neck and Bayside demolition, Pungo demolition.
Planning concrete removal?
Tell us about the property and scope and we will walk the site and send a written quote.
Message Sent!
Thank you for reaching out. Our team will get back to you shortly.